Hi,
I'm using version 9.6.1 on a Mac and have just run into a new feature. Previously in older versions of Livecode selecting a file in the IDE standalone settings tab copy file/folder would allow a single file to be selected and this was copied to the folder that contained the built engine :
Now when I select a single file it is listed and stored under a folder with the same name as the folder that source file is stored in :
With this version of the IDE it is not possible to enter just a file name like this : as even when a single file is selected its parent folder name is displayed :
IDE Stand alone settings - Copy File
Moderators: FourthWorld, heatherlaine, Klaus, kevinmiller, robinmiller
-
- Posts: 854
- Joined: Wed Nov 04, 2009 11:41 am
- Location: Gunthorpe, North Lincs, UK
IDE Stand alone settings - Copy File
best wishes
Skids
Skids
-
- Posts: 854
- Joined: Wed Nov 04, 2009 11:41 am
- Location: Gunthorpe, North Lincs, UK
Re: IDE Stand alone settings - Copy File
It seems I'm only allowed three screen shots per post .
So continuing from above:
This is probably a good idea as it allows files with the same name to be added to a project, but I wish I had read about the change before it tripped me up.
best wishes
So continuing from above:
This is probably a good idea as it allows files with the same name to be added to a project, but I wish I had read about the change before it tripped me up.
best wishes
best wishes
Skids
Skids
-
- VIP Livecode Opensource Backer
- Posts: 9695
- Joined: Wed May 06, 2009 2:28 pm
- Location: New York, NY
Re: IDE Stand alone settings - Copy File
Interesting. Is it mentioned in the release notes? This may have been placed earlier than the latest build of v.9.x.
Craig
Craig