Hi Guys
Does anybody know the best way for LC to receive and display information from sensors... effectively allowing you to make a vehicle dashboard with speedo, revs, temperature, etc?
Many Thanks
Livecode Vehicle Dashboard
Moderators: FourthWorld, heatherlaine, Klaus, kevinmiller, robinmiller
-
- VIP Livecode Opensource Backer
- Posts: 9670
- Joined: Wed May 06, 2009 2:28 pm
- Location: New York, NY
Re: Livecode Vehicle Dashboard
I have used a hardware interface for 15 years, that connects to a Mac through the USB bus. It has a framework supporting a dozen different languages, including LC.
It can read from and write to hard-wired input and output channels, and contains a few other gadgets. That company no longer supports them. I bought the last two they had, and have used a dozen over the years for this and that, including commercial applications.
But I think there is still support for LC in Raspberry-Pi and Arduino. Do a search here for those keywords. I believe they can do similar things.
Craig
It can read from and write to hard-wired input and output channels, and contains a few other gadgets. That company no longer supports them. I bought the last two they had, and have used a dozen over the years for this and that, including commercial applications.
But I think there is still support for LC in Raspberry-Pi and Arduino. Do a search here for those keywords. I believe they can do similar things.
Craig
Last edited by dunbarx on Tue Dec 07, 2021 8:56 pm, edited 1 time in total.
Re: Livecode Vehicle Dashboard
Raspberry Pi code was a sort of "unofficially" supported side project, based only on open source editions, and without support from version 7.04 onwards (meaning no build after that would work, not just "at your own risk"). Hermann (sorely missed) did some great stuff with Pi devices, and recommended version 6.something (pre Unicode refactoring) for performance reasons. If you can get the correct LiveCode installer it will still work to build for Pi, and (although perhaps "under-resourced") you can run the IDE on a Pi - even a ZeroW.
Arduino doesn't have any direct compatibility with LiveCode that I know.
I have used Velleman K8055N/VM110N USB boards with a lot of success for projects. There's a thread on this forum about my journey with support from LC staff to use LCB to build a wrapper for the manufacturer's dll and can happily interrogate and control many things with it.
viewtopic.php?p=162707#p162707
The K8055N has apparently been replaced with this equivalent http://velleman.co.uk/contents/en-uk/p303_k8055n.html - the VM110N essentially was the same thing. I see they also have a compact usb card replacing that.
Arduino doesn't have any direct compatibility with LiveCode that I know.
I have used Velleman K8055N/VM110N USB boards with a lot of success for projects. There's a thread on this forum about my journey with support from LC staff to use LCB to build a wrapper for the manufacturer's dll and can happily interrogate and control many things with it.
viewtopic.php?p=162707#p162707
The K8055N has apparently been replaced with this equivalent http://velleman.co.uk/contents/en-uk/p303_k8055n.html - the VM110N essentially was the same thing. I see they also have a compact usb card replacing that.
-
- VIP Livecode Opensource Backer
- Posts: 3581
- Joined: Mon Jan 22, 2007 7:36 am
- Location: Berkeley, CA, US
- Contact:
Re: Livecode Vehicle Dashboard
https://www.carloop.io/ makes some wonderful gadgets.
PowerDebug http://powerdebug.ahsoftware.net
PowerTools http://www.ahsoftware.net/PowerTools/PowerTools.irev
PowerTools http://www.ahsoftware.net/PowerTools/PowerTools.irev