Put list into custom property

keyless · Post by **keyless** » Thu Jul 02, 2009 1:55 am

I'm going over So Smart Software's great Managing Entry Boxes #2 tutorial.

The only thing I'm stuck on is how to load up my list of data into a custom property, or "feed" it as Eric put it.

So I have a list of file names in a variable called bList and I want to put them into a custom property called uList of field "File Name" How do i go about this.

I tried
put bList into the uList of fld "File Name"

but that doesn't seem to be right.

keyless · Post by **keyless** » Thu Jul 02, 2009 5:29 am

Never-mind, just remebered I should be using Set not Put, and it should be setting the CP to the Variable. Got it working fine, no further assistance needed.

Klaus · Post by **Klaus** » Thu Jul 02, 2009 8:34 am

Hi keyless,

I could offer no further assistance at very low and affordable fees

It is very hot over here in germany...

Best

Klaus

keyless · Post by **keyless** » Fri Jul 03, 2009 8:15 pm

Klaus wrote:Hi keyless,

I could offer no further assistance at very low and affordable fees

It is very hot over here in germany...

Best

Klaus

Thank you Klaus but I think I will check for no further assistance in the rev documentation and list, and maybe find some no further assistance open source code on the web. Perhaps if you see fit though, you might upload a stack of no further assistance to RevOnline (maybe with a banana

) so I can evaluate your work and fees.

It's very very hot here in southwest, USA too...

Klaus · Post by **Klaus** » Fri Jul 03, 2009 9:05 pm

OK, sounds reasonable