Huh, I opened it in Lc 7.1.4 (I assumed from the pics, my bad)
Hee hee
Moderators: FourthWorld, heatherlaine, Klaus, kevinmiller, robinmiller
Huh, I opened it in Lc 7.1.4 (I assumed from the pics, my bad)
Hee hee
Code: Select all
on openCard
put 1 into KOPCHE
repeat until KOPCHE > 20
put ("B" & KOPCHE) into BNAME
send "mouseUp" to btn BNAME
send "mouseUp" to btn BNAME
add 1 to KOPCHE
end repeat
end openCard
on closeCard
send "mouseUp" to btn "SAVE"
end closeCard
Code: Select all
on openCard
repeat with i = 1 to 20
send "mouseUp" to btn ("B" & i)
## Why send mouseup twice?
send "mouseUp" to btn ("B" & i)
end repeat
end openCard
Aye, well that does sound a bit daft . . . but . . .Why send mouseup twice?
Then I would not send "mouseup" at all!richmond62 wrote: ↑Sat Oct 12, 2019 9:33 amAye, well that does sound a bit daft . . . but . . .Why send mouseup twice?
The stack "TB" has the buttons saved in the condition they were in when last
used, so, if, mouseUp were sent up only once the revTools stack would end
up in exactly the reverse configuration to that saved.
I am trying to make a settings palette so that a teacher can configure a setup forI just made a stack/palette with limited buttons.